9/9/22 Reinforcing the vectored bearing holders

 

Colin Szeto

The 7mm stub broke off, there was an attempt in utilizing a 6-32 ⅞ socket head screw. This was broken when the drone platform was being stowed in between the pontoons and the cart stuck the top platform of the wam-v

Side view cross section 

Currently the 

Side view with the hole extended through the entire part

Able to add screw to reinforce

Button head screws will interfere with the 8020 rail that the cart slides on

Could have the screw head on the outside of the part


section analysis bearing holder with flat head

The flat heads doesn’t intersect the 8020

The clearance between the edge of the flat head and the bar is 4 thousands of an inch 

The screws used in the bearing cart (all screws multiplied by 8)


Previous
Previous

9/9/22 Reinforcing the vectored bearing holders

Next
Next

9/7/22 Attaching the Payload