4/26/22 Programming the CNC router paths

Apr 26

ISO GPIO access hole

top view GPIO access hole

These rectangles were originally not constrained and. The corners are unable to cut out as the 90 corner is not achievable with the bit.

After:

TOP View constrained GPIO access hole

Implemented constraints and added overcuts to the corners to be able to be cut out

Top view gps antenna mounting holes

These holes cannot be less than ⅛ in or 0.125 in in diameter. Currently, they are 3mm holes

These are 2 mm slots. Currently, the CNC machine needs a 3.10 mm slot that could go up to 4 mm to fit two vertical plates in if desired.

(we could use a 1/16 bit for these cuts)

4/26/22 Routing at Envision